Hi!

After update.

When starting calibration:
Charge up to 99% maximum
Discharge - Error= 64. Too low discharging current detected.

Tested 5 different batteries...

Please help!!!

@24it-kz 

It has nothing to do with the update.

You have to open a new topic in the Analyzer section and describe the issue. Add pictures.

Posted by: @azzido

@leminhhoang 

The new SW version 4.0.0 can detect the EV2300 or EV2400 both original and clone. You just need to select it from the device list and press Connect.

Please note that it works only for DJI Chip Reset License.

Does the need for DJI chip reset license also apply to non DJI batteries? Like internal Lenovo batteries with BQ40Z696A which need EV2300 for communication.

@rethoricalcheese 

Starting with NLBA1 PC Software version 4.0.0, all reset licenses work with EV2300/E2400 or clone.

@balavalluvan28 

What is the issue ? I see it has nothing to do with the topic title. Open a dedicated topic and describe your issue.

@azzido I'm unable to connect.

I'm getting the message that I need to update version 4.3

and when I clic on YES for automated update, I got a message telling that application will close and start automatically, and this happens but the version continue as 4.2 and also I'm unable to connect. 

Do I need to do anything additionally?

Thank you. 

 Close software. 

 Download installer from this link 

  https://www.laptopu.ro/Download/Software/V4.3.0/NLBA_LaptopBatteryAnalyzer_4.3.0.zip  

 Install it

 Run the software 

@hector450 

It is happening because you ignored the last message and you did not run the application in Administrator mode.

@azzido I was executing as Administrator, but I was able to fix it using the installer and doing a clean install. 

Thank you

@djibattworkshop Thank you friend. 

This worked. 

Regards

HELLO EVERYONE

I need  explanation of this feature, if possible, in a video

This is used for debugging purposes by the developer.

There is no need for any explanations.

It's not recommended to touch anything there.

Is there a way to increase the voltage of the cells through the program and the device, or do they have to be charged?
Externally after opening the battery

Please don't continue posting here.

If you have further questions open a dedicated topic.

These are the forum rules.