just installed onto windows 10 and software wont load
I have just received my NLBA1, downloaded 4.2, installed including drivers, rebooted and software refuses to load. So i uninstalled it. re-installed it and again same problem. I have also tried opening the program with administration rights but makes no difference. Just sits there and does nothing. So far not a great experience.
Do you have a PC with Win7 setup ?..
Actually, if you don't get any warning from the antivirus then it should be fine.
Make sure you have the correct EV2300 drivers, just install these 2 drivers in the right order:
Because you have installed other Texas Instruments tools that are using outdated drivers for EV2300.
If you have used other softwares for ev2300 then make sure you install all the steps from Download section.
You can watch this tutorial:
You can try out the pinout of the WDX0R battery:
Number of Pins: 10