Forums
NLBA1 Laptop Batter...
DJI Drone Battery C...
I request informati...
 
Notifications
Clear all

I request information about the Dji Osmo chip.

    Last Post
  RSS
laarnova
 laarnova
(@laarnova)
Estimable Member Customer

Hi, are these the connections for the DJI Osmo battery?
I'm connecting SDA/SCL and GND as shown in the photo, and it's not giving me any information. Each cell has more than 3.7V.
Thank you. I need to know what I'm doing wrong.

f3dc36b1 579d 408a a76a fa1f678531c4

 

ReplyQuote
Topic starter Posted : 03/05/2025 4:46 am
loliconic
 loliconic
(@loliconic)
Member Moderator

@laarnova 

Have you tried pressing the power button?

If the battery does not respond even with the power button pressed, you may solder a wire from the BAT+ pin on the PCB to the V pin of the green connector (which connects to the NLBA1). Once the connection is made, connect the battery, press POWER ON, and then select START READING.

ReplyQuote
Posted : 03/05/2025 6:51 am
laarnova
 laarnova
(@laarnova)
Estimable Member Customer

@loliconic Ok perfect, tomorrow I will try that system, thanks

ReplyQuote
Topic starter Posted : 03/05/2025 7:17 am
  All forum topics
  Previous Topic
Next Topic  
Share: